Camera scan doesnt show full screen?

(2 posts)

wakawu
Member

Tested on a GeoVision NVR with 8.4 and 8.5 software. Setup for 1 camera per 3 second scan but it will not show up in 'fullscreen' mode. It has a little window showing the camera and a black border around it. It initially would go to fullscreen mode when I hit camera scan so I know it's possible I just don't know what setting or what I'm missing. Tried restarting, reinstalling and upgrading to 8.5 from 8.5 with the same results. Anyone?

Posted 6 months ago #
JCHaldas
Administrator

Wakawu,

Please try enabling Directdraw in Multicam by going to Configure, General Setting, System Configure, then check "Enable Directdraw Overlay".

Please let me know if you have any further questions.

Thanks James

Posted 2 months ago #

Reply

You must log in to post.