Flashing 'M' after using event search

Tagged: , , ,

This topic contains 2 replies, has 0 voices, and was last updated by  whs 5 years, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #31258

    whs
    Member

    I am viewing 11 cameras remotely. After doing an event search, 2 or 3 cameras have a flashing 'M' on them. I hit the record button and the M goes away. When I look at the event list, it does not look accurate. It seems it is not recording all of the time.

    This happens each time I do an event search. Why do I have to start recording again each time?

    #32232

    JCHaldas
    Participant

    Hello WHS,

    Flashing "M" usually indicates that you are recording based upon motion events. This is most likely why the DVR is not recording all of the time.

    Thanks James

    #32233

    whs
    Member

    Yes, we are recording all cameras for motion only. Thanks for your assistance.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.