poor pict quality

Home > CCTV Security Camera & Video Surveillance System Forums > CCTV Cables, Network Cable, Connectors, & Installation Support > poor pict quality

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 17, 2011 at 8:29 am #31211
    Anonymous
    Inactive

    We are currently running 4 of your BIPRO-9004 cameras along with a camera from a different company.$cameras are going to a DVR on one floor. One of thoese camera is split to go upstairs to a monitor and eventually a DRV. This camera is on simease cable fromthe camera to T BNC connector then one cable goes to the DVR and the other to the monitor. It is powered by a 12v transformer. My problem is the one that goes to the monitor is not clear and in night mode I usually get waves on the monitor. What can I do to correct this?

    February 17, 2011 at 11:18 pm #32160
    Anonymous
    Inactive

    I may not have been clear in my prior post. The picture from the DRV is fine, The picture that goes to a stand alone moitor is the problem. This picture is carried on a simease cable with 12v to a BNC Tee. Fom this point one simease cable goes to a DVR (No Problem Good Pict) the second cable from the BNC Tee goes to a monitor in a differnt part of the house. I thinking I need some type of booster to increase the signal to the monitor

    February 17, 2011 at 11:48 pm #32161
    Mike Haldas
    Keymaster

    Hello Samuraidad,

    You will be better off using our AMP-1002. It is an amplifier/splitter. It will do a better job with the split and should eliminate the quality drop issue you are having.

    Please let me know if you have any questions.

    Thanks James

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.