What terminal block posts do I hook up the rs485 and sensor?

This topic is empty.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 7, 2011 at 10:33 pm #31245

Anonymous
Inactive

I ran a cat five to the (PTZ-WIR12X) IR PTZ Camera. There is a single black wire that comes out of the camera with the wiring harness which I am clueless of what to do with as well as the installation instructions not being clear on where to hook the rs-485 two conductor and also the sensor wires. I would appreciate where I could find a manual or get the terminal block diagram. the small block from left to right:

NO NC CM G AX the CM and the G are white and the rest are yellow. The larger terminal from the left to right: . . G s1 s2 s3 s4< I assume that this terminal block may be for sensors. Any help will be appreciated.

May 11, 2011 at 1:35 pm #32214

Mike Haldas
Keymaster

Hello ScottFuel,

Here is what the terminals on the PTZ are for.

NO: Normally Open

NC: Normally Closed

CM: Common

G: Ground

And for the G S1 S2 S3 S4 seem to be for sensor inputs.

G: Ground (used for all Sensor ports)

S1: Input Sensor 1

S2: Input Sensor 2

S3: Input Sensor 3

S4: Input Sensor 4

I hope this helps

Thanks James
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.