Camera scan doesnt show full screen?

Home > CCTV Security Camera & Video Surveillance System Forums > Geovision Surveillance Support > Camera scan doesnt show full screen?

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 9, 2011 at 2:49 pm #31368
    Anonymous
    Inactive

    Tested on a GeoVision NVR with 8.4 and 8.5 software. Setup for 1 camera per 3 second scan but it will not show up in 'fullscreen' mode. It has a little window showing the camera and a black border around it. It initially would go to fullscreen mode when I hit camera scan so I know it's possible I just don't know what setting or what I'm missing. Tried restarting, reinstalling and upgrading to 8.5 from 8.5 with the same results. Anyone?

    February 24, 2012 at 7:53 pm #32307
    Mike Haldas
    Keymaster

    Wakawu,

    Please try enabling Directdraw in Multicam by going to Configure, General Setting, System Configure, then check "Enable Directdraw Overlay".

    Please let me know if you have any further questions.

    Thanks James

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.