Jailbars displayed on camera video of Geovision system

This topic is empty.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
October 1, 2012 at 12:36 pm #31512

Anonymous
Inactive

I am using geovision 8.2 2008 on a windows XP machine with a GeoVision GV-1240 card. When first powering up video is normal for about 10 seconds, after that all cameras (6) show jailbars in the displayed video. Thanks in advance for your help.

October 19, 2012 at 6:15 pm #32415

Mike Haldas
Keymaster

Mike,

Thank You for your post. I highly recommend that before proceeding with any additional troubleshooting, that you upgrade to the latest version of Geovision software.

If the problem persists, disconnect all of the cameras from the Geovision card. Then connect them one at a time. Take note of when the problem occurs. In other words, are the video feeds fine until you connect a certain camera? If that is the case, you may have a bad cable that is not grounded and causing all of the other videos to be bad.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.