Home > CCTV Security Camera & Video Surveillance System Forums > Remote Internet Viewing Setup > H 264 DVR local network login failed
- This topic is empty.
December 1, 2011 at 10:15 pm #31379AnonymousInactive
I have a H.264 DVR and I think I have everything set up so that I can view it over my network. I installed the active x control and get to the login page.
I have checked that the control port is set to 5050 and the username is admin and I changed the password is 000000.
I get a small pop up with the title "Prompt" and the message login failed everytime.
JasonJuly 24, 2012 at 6:58 am #32319AnonymousInactive
Hi, I have the same problem with Jasons,
When I try to view the DVR through local network. run \192.168.1.10 , thes creen comes with login interface
command port: 5050
I tried user name ADMIN/admin, password:111111 as the user name and password when I first login to set up the DVR.
The Promt window come up with message "Login failed"
Could someone please help me. I was stuck.
Please.September 10, 2012 at 8:08 pm #32320Mike HaldasKeymaster
If your password is not working, most DVRs have an override password reset or master password that enables you to login to the DVR to reset the password. For example, here is a link to a page that shows you how to reset your password on iDVR-PRO CCTV DVRs.
At this point, I would recommend doing that if you can find the instructions specific for your model DVR.January 1, 2013 at 9:28 pm #32321AnonymousInactive
HI CAN SOMEONE PLEASE HELP!!!January 1, 2013 at 9:30 pm #32322AnonymousInactive
purchased and installed a 16 h.264 dvr and very much able to log in within the network. however i can't manage to log in outside the network. i am minutes away from throwing this halfway across the world… ps. should have stock to digimerge maybe? or is it my configurations? please help thank youJanuary 2, 2013 at 8:39 pm #32323Mike HaldasKeymaster
Please NOTE: H.264 is not a DVR model it is a compression that almost every DVR on the market currently uses.
If you are not able to remotely view the DVR,it is most likely because you have not forwarded the ports for the DVR.
You will need to figure out what port the DVR is running on (you can typically find this in the network menu of the DVR). Once you have the port you will need to log into your router and forward that port.
If the DVR was purchased through us we will have instructions in our support and knowledge base — https://www.cctvcamerapros.com/Surveillance-Knowledge-Base-s/57.htm
Please let me know if you have any questions.
- You must be logged in to reply to this topic.