Manual Focus and Zoom on Dome Camera

Home > CCTV Security Camera & Video Surveillance System Forums > CCTV Security Camera Support > Manual Focus and Zoom on Dome Camera

  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 24, 2009 at 9:26 pm #31018
    Anonymous
    Inactive

    I hope somebody can advise me. I have installed a new CCTV dome with manual focus and zoom which is adjusted by a small screw fitting either sied of the dome. This feature is not covered in the instructions though. Assuming this is fairly common set up deos anyone have advice as the picture I am receiving is very poor, blurred and milky and finely adjusting the screws causes loss of picture. Help! Please people !

    December 3, 2009 at 12:42 pm #31908
    Mike Haldas
    Keymaster

    Philster,

    Please let me know if the camera you are referring to was purchased from CCTV Camera Pros so that we can try to duplicate the issue and help you.

    All of our dome CCTV cameras can be found here:

    https://www.cctvcamerapros.com/Dome-Security-Cameras-s/22.htm

    Thank You.

    -Mike

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.